The use of two sturdy, independent plastic brackets means its width conforms to your needs. Whether mounting in portrait or landscape mode our mount will match the width you need. Any tablet/case combination that is 11 mm thick or less will fit into the Koala Mount. If your device (with or without a case) is thicker than 11 mm, see our Koala Mount 2.0.
Simple Setup and Damage-free Removal
Attaches with 3M Command Adhesive Strips, so no screws and no damage to your wall/mounting surface. They can be moved from one location to another (new strips required if removing). Setup and removal is simple and takes minutes, with no tools required.
IMPORTANT: Not intended for areas exposed to heat or moisture (like a bathroom with a shower/bathtub), there are special Water/Heat Resistant Strips for that. They're also not designed to work on textured surfaces or wallpapers.
Package Contents: 2 ABS plastic brackets, 2 Large 3M Command Strips, cleaning pad, full setup and removal instructions.
No Fallen Cords; Hidden Command Tabs
Built-In clips keep your cord off the floor and conveniently hold your cord in place when you're ready to use it again.
The Koala Mount was specifically designed with a slot at the top to conveniently hide the Command Strip tab (the rounded end that doesn't have adhesive on it). Tuck it into the slot and it's completely hidden until you need it. Easily fish it out when the time comes.
No Covered Buttons
Precise cut-outs ensure full functionality on most devices. You'll be able to charge, power up, and adjust the volume of your device all while in the mount.
Note: While it does fit most popular tablets, the bracket supports can block ports/buttons on either side between 1.5 - 3.75 inches up from the bottom (7-8" tablets, like the iPad Mini may have blocked ports in landscape mode - see our Koala Mount 2.0 if this may be an issue).